When the tension gets goes down the relay turns itself off again. When the tension of the battery is above a certain point, then it sends out the switched power. This relay measures the tension of the battery when the motor is running. Q: Are you ought to connect the extension kit for +15/+30 on a switched circuit?Ī: This is not required, because the relay used in this extension kit is a smart relay. Your 13 pin wiring kit is however prepared for a +15/+30 connection for which you can order an extension kit. Q: I have a 13 pin wiring kit, but I don’t have +15/+30 on my socket.Ī: This is because not everyone needs +15/+30, even with a 13 pin wiring kit. It is also possible that a vehicle is already equipped with a switch or a button on the dashboard which can be used to switch of the parking sensors.Other kits have a multifunctional module which can be installed to cut off the parking sensors universally.For some wiring kits you need an extension kit for disconnecting the parking sensors.After installing, the parking sensors will disconnect automatically when a trailer is connected. There are wiring kits who need to be coded for all functions.Q: How can I disconnect the parking sensors when I connect a trailer.
In case the connection of the Can-bus wires is broken or not right then there is always a working brake light on the trailer during car driving. If we make a direct connection this can be prevented. Q: Why do I have to connect an extra wire for the brake light when all functions on the trailer work via the Can-Bus network?Ī: When there is a lot of activity on the Can-Bus network, the brake light on the trailer will be delayed.
Disconnect 7 pin trailer connector manual#
It is also indicated in our manual or on our yellow helpline cart which are included in the box. This position is for the mechanical elimination of the fog light cut off on the car. Q: On what position do I need to connect the grey wire in the socket?Ī: The grey wire needs to be connected on position 2a. Q: Is it necessary to connect the power supply if I do not need +30 / constant current? This is because this wire can also be the power supply for the module or relay of the wiring kit.
Q: Is it necessary to connect the power supply if I have a 7 pin wiring kit?Ī: It is always necessary to connect the power supply. Our module translates these signals to the sockets. The light signals can be retrieved from this network. In Germany, Austria and the United Kingdom it is obligatory.Ī: A Can-Bus system is a computer network that passes through the vehicle. This is indicated by means of a visible our audible signal on the dashboard. for a caravan).Ī: This is a system that indicates if a turn light is defective. For 13-pole one chooses if constant tension is necessary (e.g. Q: When to choose for a 7- or 13-pole set?Ī: For 7-pole one chooses if no constant tension is necessary (e.g.
Do you have any questions about the installation of an ECS wiring kit? Most answers can be found on this page.
0 kommentar(er)
